Cover the roof with felt paper. Finally, nail the first row of shingles directly above and align with the starting row. Use four roofing nails per tile, as directed in the package instructions (six nails in windy areas). Once this course is laid, you can start cutting horizontal lines of chalk on the ceiling to secure straight rows.
Be sure to expose 5 in. From the tabs of the shingles where the lower edge of the tab meets the top of the cutout. Usually, everything that is on the roof is removed to the plywood during the replacement of the roof. This includes the entire underlayment, flashings and thousands of shingles and nails.
The drip molding carries rainwater directly into the roof gutters. Take the roofing nails and the chalk line. Align the drip molds and separate each installation nail by 12 inches. Mark these spaces with chalk and start nailing.
Nail the valley of your roof flickering the same way. Whether you have hired a professional or plan to install a roof yourself, understanding the roof installation process and the necessary steps will help you ensure that your new roof is properly installed. If you follow these steps accurately, you will install a roof that maximizes its capabilities and service life without any problems. Drive the step into the wall towards the top of the flashing at the end that is closest to the spout, so that the next step of in-line flickering covers the nail.
The first step is perhaps the most obvious: you have to clean the old roof to prepare the installation of the new one. This is an often overlooked step, but a perfectly straight ridge is essential for the total protection of your roof. Installing a new shingle roof is a big commitment, so understanding all the steps involved in a roof replacement process from start to finish can be very beneficial to you as a homeowner. This is where your contractor takes all necessary steps to ensure they protect your property during roof replacement.
You can't afford to skip this step, and it's the perfect opportunity to fix the roof deck when you already have it open anyway. Install the next row of shingles over the first step, then cover that row with a flashing, and so on.